Webinar

Using modeFrontier-TurboOPT II integration node to run FEA and CFD optimization studies

ESTECO Webinar series using new modeFRONTIER TurboOPT II Node

In this webinar, experts from CN and ESTECO gives a short presentation of the two software packages and demonstrate the process of integrating a TurboOPT II model with modeFRONTIER.

Watch the webinar to learn more about the following 3 test cases:

  1. Axial fan blade section optimization using AxCent® and Pushbutton CFD® analysis
  2. Centrifugal pump multi-disciplinary optimization (MDO) with CFD and at design and off design conditions
  3. MDO of a compressor third stage impeller using CFD and FEA analysis
This field is required.
This field is required.
This field must be a valid email address.
This field is required.
This field is required.
This field is required.
This field is required.

By submitting this form, I acknowledge I’ve read the ESTECO Privacy Policy.

There was a problem with your submission

Please try again later.